Reliable and coffee-latency communication between all motors, pedestrians, infrastructure, and networks (V2X) is arguably the main protection factor of the vehicle, independent operation. Specifically, time, vital functions such as collision avoidance or cooperative driving maneuvers may be significantly affected despite the slightest delay in communication. Processing based on the traditional cloud calls for an additional backhaul delay, which, consequently, makes the street environment much less responsive, the actual time. Multi Access Edge Computing (MEC) became the challenge of this paper and it was asked whether it can be powerful in reducing spherical, travel delay in the case of cars, to, whole lot (V2X) interactions supported through a VANET infrastructure. Python is used. An analytical delay version was hired to demonstrate the difference in latency between cloud, handiest, and aspect, assisted processing through an RSU. The vehicle experimental setup includes safety messages from 10 vehicles of different sizes. The overall performance of the system was measured through the average give up, to, stop latency, and the choice fulfillment rate. MEC implementation contributes greatly to the reduction of latency and therefore the reliability of time, sensitive car, oriented choice, making received progress. The results show that MEC will be the key technology enabling true, time autonomous automotive packages.
Introduction
The study focuses on improving Vehicle-to-Everything (V2X) communication using Multi-Access Edge Computing (MEC) to reduce communication latency and improve reliability in intelligent transportation systems and autonomous vehicles.
V2X is a wireless communication technology that allows vehicles to exchange information with their surroundings through four main communication types: Vehicle-to-Vehicle (V2V), Vehicle-to-Infrastructure (V2I), Vehicle-to-Network (V2N), and Vehicle-to-Pedestrian (V2P). These technologies support road safety, collision avoidance, cooperative driving, traffic management, lane-change assistance, and pedestrian protection.
One of the major challenges in V2X communication is achieving extremely low latency and high reliability, particularly for safety-critical applications such as emergency braking and collision warnings. Traditional cloud-based communication can introduce delays because data must travel through cellular networks to centralized cloud servers for processing.
To overcome this limitation, the study proposes Multi-Access Edge Computing (MEC), which places computing and storage resources closer to vehicles, particularly at Roadside Units (RSUs). This allows safety-related information to be processed locally, reducing communication distance, processing delays, and dependence on centralized cloud servers. Emerging 5G and future 6G technologies further support these developments through advanced network capabilities, high bandwidth, and ultra-reliable low-latency communication (URLLC).
The literature review highlights the importance of artificial intelligence, machine learning, adaptive network selection, and optimized communication architectures for improving V2X performance, especially in dense traffic conditions.
The proposed methodology compares two communication architectures:
Cloud-based architecture: Vehicles send safety messages to centralized cloud servers through cellular networks. The cloud processes the information and sends responses back to vehicles, potentially increasing overall latency.
MEC-based architecture: Vehicles communicate with nearby RSUs equipped with edge servers. These servers process information locally and provide faster responses, reducing communication delays.
Vehicle movement and traffic conditions are simulated using Simulation of Urban Mobility (SUMO), an open-source traffic simulation tool. It models vehicle speed, acceleration, braking, lane changes, routes, and intersection movements.
The study also introduces a task generation model in which vehicles generate safety-related messages, including collision warnings, cooperative driving alerts, emergency braking notifications, and traffic updates. Each task is characterized by packet size, computational requirements, priority level, and deadline constraints. These tasks are processed either by centralized cloud servers or nearby MEC servers.
Finally, latency modelling is used to compare the performance of both architectures. Total communication latency is divided into three main components: transmission delay, propagation delay, and processing delay.
Conclusion
Self-driving motors need highly reliable and intermittent-latency communication for defense-essential applications such as emergency braking, hitting a pedestrian, and driving in a cooperative guy-ner. The traditional cloud-based totally Vehicle-to-Everything (V2X) structures are too latency heavy due to conversation through backhaul and middle networks. Therefore, they cannot help with real-time selection. This paper investigated the impact of Multi-Access Edge Computing (MEC) on latency in automotive oral exchange through automotive ad-hoc networks (VANETs). For vehicle motion modeling, SUMO changed to used, and Python changed to used for modeling latency, simulates the setup as compared to a cloud-primary based tool with an aspect computer gadget based on roadside gadgets (RSUs), where ten cars had been and sent to a protection fact.
It appears deferred become greatly reduced through the target calculation-ing method due to fact records modified to be taken into the direction of the car. Because of this, the share of successful latency requirement pride went up These results screen that MEC is one of the main ingredients in the development of next-technology intelligent transportation systems with a view to relying on 5G NR-V2X and, in addition down the road, likely even 6G networks.
The transition from cloud processing that is fully centralized to V2X communication, this is supported by aspect nodes allocated, is the way forward, which in line with this study to real-time, reliable self-sufficiency using.
References
[1] M. Kaur and P. Singh, “V2X communication systems: Architecture and applications,” Springer Book Chapter, 2025.
[2] R. Zhang, K. Xiong, H. Du, D. Niyato, J. Kang, X. Shen, and H. V. Poor, “Generative AI-enabled vehicular networks: Fundamentals, framework, and case study,” arXiv preprint arXiv:2304.11098, 2023.
[3] R. Hao et al., “Research challenges and progress in the end-to-end V2X cooperative autonomous driving competition,” arXiv preprint arXiv:2507.21610, 2025.
[4] S. Zhang, H. Liu, and X. Shen, “Edge intelligence for autonomous vehicular networks: Architectures and applications,” IEEE Internet of Things Journal, 2025.
[5] D. Wang, A. Qiu, Q. Zhou, and H. D. Schotten, “A survey on the role of artificial intelligence and machine learning in 6G-V2X applications,” arXiv preprint arXiv:2506.09512, 2025.
[6] Y. Mao, C. You, J. Zhang, K. Huang, and K. B. Letaief, “Mobile Edge Computing: Survey and Research Outlook,” IEEE Communications Surveys & Tutorials, vol. 19, no. 4, pp. 2322–2358, 2017.
[7] T. Taleb, K. Samdanis, B. Mada, H. Flinck, S. Dutta, and D. Sabella, “On Multi-Access Edge Computing: A Survey of the Emerging 5G Network Edge Architecture and Orchestration,” IEEE Communications Surveys & Tutorials, vol. 19, no. 3, pp. 1657–1681, 2017.
[8] F. Marzuk, A. Vejar, and P. Cho?da, “Deep reinforcement learning for energy-efficient 6G V2X networks,” Electronics, vol. 14, no. 6, p. 1148, 2025.
[9] X. Hou, Y. Li, M. Chen, D. Wu, D. Jin, and S. Chen, “Vehicular Fog Computing: A Viewpoint of Vehicles as the Infrastructures,” IEEE Transactions on Vehicular Technology, vol. 65, no. 6, pp. 3860–3873, 2016.
[10] Y. Li, Z. Chen, and M. Gerla, “Adaptive network selection for latency-aware V2X systems under varying network and vehicle densities,” IEEE Transactions on Intelligent Transportation Systems, 2025.
[11] X. Liu, H. Zhang, and Y. Wang, “Sequential task assignment and resource allocation in V2X-enabled mobile edge computing,” IEEE Internet of Things Journal, 2025.
[12] J. Park and S. Kim, “Architecture optimization for dense vehicular communication networks,” Vehicular Networks, ScienceDirect, 2026.
[13] P. Krajzewicz, J. Erdmann, M. Behrisch, and L. Bieker, “Recent Devel-opment and Applications of SUMO – Simulation of Urban Mobility,” International Journal on Advances in Systems and Measurements, vol. 5, no. 3–4, pp. 128–138, 2012.
[14] M. Chen, Y. Hao, L. Hu, K. Huang, and V. C. M. Leung, “Edge Artificial Intelligence for 6G: Vision, Enabling Technologies, and Applications,” IEEE Communications Surveys & Tutorials, vol. 24, no. 1, pp. 144–180, 2022.
[15] K. Wang, Y. Wang, and X. Li, “Latency-aware task offloading for edge-based vehicular networks,” IEEE Access, 2025.
[16] C. Zhao, X. Yue, M. Chen, G. Wang, and T. Wang, “Load-Aware Multi-Task Offloading Strategy Based on Optimal Stopping Theory in Mobile Edge Computing,” Intelligent and Converged Networks, vol. 6, no. 3, pp. 234–246, 2025.
[17] J. Bo and X. Zhao, “Vehicle Edge Computing Task Offloading Strategy Based on Multi-Agent Deep Reinforcement Learning,” Journal of Grid Computing, vol. 23, no. 1, 2025.
[18] W. Zhou, H. Li, and Z. Chen, “Deep Reinforcement Learning Based Task Offloading for Vehicular Edge Computing Networks,” Vehicular Communications, 2025.
[19] F. Zeng, Y. Liu, and Z. Chen, “Task Offloading Delay Minimization in Vehicular Edge Computing Networks,” Digital Communications and Networks, 2025.
[20] Y. Wu, H. Chen, and X. Shen, “Intelligent Offloading Balance for Vehicular Edge Computing Networks,” IEEE Transactions on Intelligent Transportation Systems, 2025.